If you go away for an extended period, Zip recommends you turn off your G3 HydroTap to save water and energy.

If you go away for an extended period, Zip recommends you turn off your G3 HydroTap to save water and energy. If you have a Sparkling G3 HydroTap please use instructions here

To Turn OFF
Step 1: Turn the water off at the supply.

Step 2: Depress the levers on the HydroTap three or four times until the water stops. This will empty the tanks.

Step 3: Turn off power supply at the power point.

 

To Turn ON 

Step 1: Turn on water supply at supply point. Turn on power supply at power point. Note: any programmed times will be retained via the battery backup and will not need to be re-set.

Step 2: Go to the command centre, scroll through the menu with [MENU Λ or MENU V] keys on left of screen and navigate to [Filter Flush]. 

Step 3: Open the filter flush stop-valve and ensure the end of the hose is in a bucket or the sink. 

Step 4: Press [Adjust Λ] to the right of the screen, this will start the flow of water and [Filter Flush – ON] will be displayed. Flush for 30 seconds to remove any water sitting in the filter cartridge. 

Step 5: Once the filter flush completed, turn filter flush [OFF] by pressing [Adjust V], then turn Stop Value to OFF by rotating the lever anti-clockwise until it is at 90 degrees to the filter flush hose. Put the hose back into the filter compartment.

Step 6: Press[MENU Λ or MENU V] to exit the Filter Flush screen. Your unit will return to normal operation after approximately 10 seconds.